Power Control Panel Issues

[evanperryg]

How old are your batteries? Even if they still charge up to 12-12.5V doesn't mean they're still in usable condition. We still have a battery from 2009 that charges up to 12.5, and will stay there for a long time under small loads, but discharges very quickly when used on a robot. We keep it for the scouting system, and for testing individual mechanisms.

[dcastaldini]

Brand new. Bought this year.

[philso]

If you are draining brand new batteries in just a few seconds, you are likely to have some issue such as two motors on the same side of the drivetrain that are fighting each other. Please start by follow the instructions in the 43 post of the following thread.

http://www.chiefdelphi.com/forums/sh...=145310&page=3

[dcastaldini]

I would think that too, but when we swapped panels, the problem went away. That doesn't mean they weren't wired incorrectly into the panel, however, that's really unlikely as that we check and double checked the wires coming in before we swapped. Occam's Razor would lead us to think that its fighting motors, but that didn't seem to be the case.
That's why I was wondering if there was a way to test the panel off the bot.

That said, I've copied off your troubleshooting steps, formatted them for a word document and am printing them off to post in our room as just plain a good idea.

[MetaEngineer]

By heavy gauge wires do you mean the wires going between the battery and PDP and the main breaker? Or the wires going to a motor and motor controller?

When using the "bad" PDPs, what voltage do you see on the driver station when the robot is just sitting still with a fresh battery?

Does anything get hot while the robot just sits there turned on?