Can connect to the roboRIO by IP but not by hostname

The flux capacitor should have been allowed under the flowchart as long as it met the single component maximum cost. I did check with Digikey and they no longer carry the line. - Al Skierkiewicz [more]

		Chief Delphi > Technical > Programming
Can connect to the roboRIO by IP but not by hostname

Thread Tools

Rate Thread

Display Modes

#19

09-03-2016, 17:14

josephno1

Registered User

FRC #3647

Team Role: Programmer

Join Date: Oct 2015

Rookie Year: 2015

Location: murica

Posts: 21

josephno1 is an unknown quantity at this point

Re: Can connect to the roboRIO by IP but not by hostname

I had the same issue.
Ended up just plugging in a USB printer cable and connecting to the roboRIO (The ip when connected via usb is always 172.22.11.2).
Then I changed it to a static ip and changed it to 10.36.47.2
To connect to the robot, change your IPV4 address to a static one. I used 10.36.47.5

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:56.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.