|
|
|
 Getting a swerve to drive predictably and effectively is arguably harder than designing and building it.
- Holtzman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Getting a swerve to drive predictably and effectively is arguably harder than designing and building it.
- Holtzman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
10-03-2016, 17:33
|
||||||
|
||||||
|
Re: pic: New low bar flaps
I missed this update.
What are they actually made of? Looks a lot like ABS sheet that I've used on so many robots. In 0.020" thickness it comes in rolls and it's pretty cheap ($2 per ft for 6" wide strips) Dr. Joe J. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode