Antenna design

[DRH2o]

We used Orange Fiberglas arrows ($3.00 each at Dick's Sporting Goods) with two different color fletchings. We cut the points off and epoxied to door stop springs ($1.50 for two at Lowe's). They work great!!

[Steven Smith]

I think it's important to go with something pivoted front/back or that can't bend sideways like those lexan strips, other wise you risk them bending sideways out of the 15". Also having 2 colors front/back or side to side so the driver will know the orientation of the robot.

Because the Lexan strips we (3005) use have 0.125" thickness in the front/back orientation and ~2" in the side to side, they have a fairly large resistance to bending in the side-to-side direction, while folding over easily in the forward/back.

If you were to grab one and forcibly twist it while pulling sideways, you might be able to get it outside of 15", but they don't interact with the defenses that way, nor do they have enough weight to do so on their own.

[Nate Laverdure]

Originally Posted by DRH2o

We used Orange Fiberglas arrows ($3.00 each at Dick's Sporting Goods) with two different color fletchings. We cut the points off and epoxied to door stop springs ($1.50 for two at Lowe's). They work great!!

Here's some photos we snapped of 1598's flag implementation at VADOS. Looks great to us!

2363's flag solution really suffered when it got battered by the low bar. At our most recent event (VAPOR), about 14% of all our recorded pit activity went towards flag maintenance/repair, mostly in <5 person*minute chunks. Our drivers really liked having them though.

[Cr1spyBacon8r]

I saw one team with long zip ties with small colored flags from duct tape

[EricLeifermann]

Our is 1/2" ID 3/4" OD Nylon tube that encase LEDs. LEDs, where not used at our 1st competition but will be used next week in Minneapolis.

[Kevin Sevcik]

Originally Posted by kevin.li.rit

I suggested we get a bunch of fans and hook it up to a speed controller and get a inflatable tube man. Unfortunately my idea was shot down

https://youtu.be/cvaRGiMWRaE

The students wanted to go with this idea for a while so we could deflate when going under the low bar and such. After a bit of prototyping and a fried/melted hair-dryer they decided it wasn't feasible on an FRC bot.

[mrwright]

We have had a lot of requests on our flag design. We call them our "ding-a-lings"

We definitely got a kick out of it when the game announcer started calling them by their names as well.

Overall they are pretty simple.

We bought ATV flags from this site:

http://aditudegear.com/flags

We also bought a spring mount like this:

http://www.amazon.com/Wheeler-Whip-S.../dp/B005HJL94A

The spring mount was far too rigid so we went to Lowes and bought another spring and custom turned a plug to press fit it in the spring that was better suited for us. It is the same exact concept as the one I referenced above.

We then mounted this spring base to an angle bracket on the side of our poly-carbonate shields. You can kind of see the mounting application on the picture that the OP provided.

They work great for us and we love the visibility that they provide. They also help us square up on the defenses better because we can see them over the tall defenses.

Hopefully this helps!

[Steven Smith]

We have had a lot of requests on our flag design. We call them our "ding-a-lings"

Glad it isn't just us... we call ours wigglydoodads. We could not get the game announcer to do so at either regional event... so really holding out for champs!