|
|
|
 If you don't like physical play build a stronger robot. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you don't like physical play build a stronger robot. - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Talon SRX - 3 Dead
I hope you get a good answer. We had a similar thing happened. We have a CIMcoder going into our Talon SRX, and I think some shaddy soldering of resistors onto the Talon SRX breakout board for the CIMcoder shorted out the CAN bus. Still powers up fine, just can't get any CAN communication.
I emailed CTRE awhile ago and never heard back. I figured I'll try again after competition season is done. 
|
|
#2
11-04-2016, 20:36
|
|||
|
|||
|
Re: Talon SRX - 3 Dead
We cooked an SRX when we had a limit switch accidentally grounded to the frame and also accidentally had our off board compressor wire (+) touching the the frame. Lots of smoke from the small ribon cable and the Talon was done. Nothing like a stupid wiring mistake to throw away over $100 in 2 seconds.
|
|
#3
11-04-2016, 21:52
|
||||
|
||||
|
Re: Talon SRX - 3 Dead
Hey Jon,
Go ahead and email support@crosstheroadelectronics.com, if you haven't already. @ahartnet I don't see your email anywhere, are you certain you contacted us? Resend when you get a chance.
|
|
#4
11-04-2016, 22:01
|
||||
|
||||
|
Re: Talon SRX - 3 Dead
Found out it never left my outbox folder for some reason. Hopefully it's made its way to y'all now.
Should have figured something was up when I didn't get a response pretty quickly.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
