|
|
|
 The rules are the rules, but if the rules get so ridiculous some of us may choose not to play anymore and that is the bigger shame.
- Paul Copioli [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The rules are the rules, but if the rules get so ridiculous some of us may choose not to play anymore and that is the bigger shame.
- Paul Copioli [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
15-04-2016, 11:34
|
||||
|
||||
|
Re: New benchtop mill
220-240V is typically single phase. 208-230V is typical three phase.
You can get static phase converters pretty cheap these days. If the motor is rated for inverter duty, you can get a variable frequency drive. If you only have 120V available, there are VFDs for running three phase 208-230V motors, but you are limited in power. A lot of knee mills are single phase, just check the motor nameplate. Last edited by protoserge : 15-04-2016 at 11:41. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode