How can CAD be helpful to Electrical?

[CalTran]

Not necessarily conventional CAD, but making wire diagrams and labeling ends does wonders for troubleshooting mid competition. My team used NI Multisim, but it could feasibly be done in any standard CAD program.

[Chris_Elston]

Each year, on 1501, the electrical team draws the robot's electrical print in AutoDesk Electrical. Not only does it help with wire labels and troubleshooting, you can also use it for inspection to prove many, many questions you are asked like wire gauge, speed controller QTY's etc... here you can download a set of electrical from our 2015 robot Otis. This set was drawn by a student Johanna A.

https://www.dropbox.com/sh/evzdecjbg...tPlDtf3Pa?dl=0

[Chak]

You can locate and plan to securely mount the battery close to an area reserved for the electronics board. That's edging closer to mechanical than electrical though.

[pilleya]

Originally Posted by Chak

You can locate and plan to securely mount the battery close to an area reserved for the electronics board. That's edging closer to mechanical than electrical though.

This year we CNC milled and bent, a custom battery mount to allow the battery to lie flat. We focused more on lowering the centre of gravity and ensuring a strong mounting, then really on keeping it organised. I would probably call this bit mechanical, but it doesn't particularly matter.

[Mechvet]

Originally Posted by waterbott

Our team is trying to fully integrate CAD into robotics design for next year. In what ways can CAD be helpful to the Electrical team? All I can think of is teaching how to design an electrical board on CAD.

For some background, our team uses Solidworks student edition.

SW student comes with Solidworks Electrical, which is an outstanding product for harness routing, wire planning, and harness assembly.

Set aside an hour or so, and watch this video for some solid tips on using the platform.

A short explanation of an FRC project is as follows:
1. Identify each electrical component, and set up a pin-out diagram for each.
2. Inside normal Solidworks, position each electrical component where it will go.
3. Go into SW electrical and lay out the wirepaths on a basic project.
4. Enable the Routing tool for SW, and begin routing wires, connectors, terminals, and wire securing methods in your robot design.
5. As you do this, SW electrical will be updating the lengths for every section of the harness.

After you're done, you'll be left with a nice, printable harness diagram that allows you to make (most of) the harness on a table, then lay it in and secure it into the robot.

Using the electrical design tools included with Solidworks can make for a VERY powerful design suite.