pic: Our x1902 Stuffed Oreo, See You In St. Louis

[cbale2000]

What reduction are you using on that pair of 775pros out of curiosity?

[XenObliv]

Originally Posted by cbale2000

What reduction are you using on that pair of 775pros out of curiosity?

The gearbox is a 1:1. So no reduction.

[Max Boord]

Originally Posted by XenObliv

The gearbox is a 1:1. So no reduction.

What compression?

Also have you guys tried running wider wheels or multiple wheels in a line? That seemed to help with accuracy and power over doing the small-big-small wheeled approach.

[XenObliv]

Originally Posted by Max Boord

What compression?

Also have you guys tried running wider wheels or multiple wheels in a line? That seemed to help with accuracy and power over doing the small-big-small wheeled approach.

The ball gets compressed about two and a half inches. We have not tried more than the one lunacy wheel, the smaller wheels are simply be used as flywheels. The compression seems to be only relevant to the friction, which to limit the rotational energy so that more of the total energy goes towards transnational. This gets a straighter shot, one without backspin, allowing us to be very accurate close up.

[BenHildy]

Looks like you guys were using your wheels for a much more constructive purpose than we were. We just ran ours at ridiculous speeds and let it bounce on the floor while spinning. We regret that, as it was quite dangerous.

[cbale2000]

Originally Posted by XenObliv

The gearbox is a 1:1. So no reduction.

Wow, and here I thought our 3:1 was overkill.

[Michael Hill]

I came into this thread hoping for a bacon-stuffed Oreo (hey, it's not out of the question. Have you SEEN the Oreo fillings that have been out lately?)