Usign a 2-1/2 bore, 24" stroke pneumatic cylinder.

I think that everyone should just take a step back and look at the whole picture, FIRST is a family, not an organization full of regions, we all try to help each other, not 'cause it benefits us, but because it's graciously proffesional. - Mike Schroeder [more]

		Chief Delphi > Technical > Pneumatics
Usign a 2-1/2 bore, 24" stroke pneumatic cylinder.

Thread Tools

Rate Thread

Display Modes

#18

18-04-2016, 09:16

CloakAndDagger CloakAndDagger is offline

Registered User

FRC #0074 (CHAOS)

Team Role: Programmer

Join Date: Apr 2016

Rookie Year: 2015

Location: Holland, MI

Posts: 24

CloakAndDagger is on a distinguished road

Re: Usign a 2-1/2 bore, 24" stroke pneumatic cylinder.

We use two 1 3/4" BIMBA cylinders, and hang by the rods. We haven't had any pneumatic problems yet

We have 5 air tanks also, and run it off of two solenoids and two regulators. The solenoids each lead to both cylinders, and are slaved together. We do this because the internal diameter of one solenoid it too small to facilitate rapid airflow

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:12.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.