|
Splines - Vertex #
Hey, i have a little question about the numbering of the vertex's in a spline. (which becomes important when using cross section).
I know that there is the make first which will define that vertex 1. However, if the direction is in the wrong way (counter-clockwise) and you need it to go the other way to match with another spline, is there a way to reverse the vertex numbering?
Thanks
__________________
Team 201 - 2003 Great Lakes Semifinalists & 2003 Archimedes Division Finalists :|: Webmaster of www.feds201.com -> FBI Scouting
Winner of The 2003 ChiefDelphi Web Award for: User That Started The Most Non Chit Chat Threads
Winner of: 2003 FIRST Ventures with 5451.68 End Points
All about me: http://knehcsa.vze.com
**Check out the New FIRST Scouting Network**
|
If this information is not 100% correct, you should follow the default advice I have for when anything goes wrong: Blame the Programmers - IKE [more] 
Similar Threads
Linear Mode
