Motor sizing - Page 2 - Chief Delphi

Scoring ringers is going to be like dating. While a select few will master it with relative ease, the vast majority will need quite a bit of time to refine their skills to an acceptable level. - artdutra04 [more]

		Chief Delphi > Technical > Motors
Motor sizing

Thread Tools

Rate Thread

Display Modes

12-05-2016, 22:57

mreda

Registered User

no team

Join Date: May 2016

Location: NJ

Posts: 24

mreda is an unknown quantity at this point

Motor sizing

Hi,
I have a question about what size motor I should get for a project I'm working on. The robot will be 18" diameter with two 4" treads lining the base. I need two motors, one for each tread. It doesnt have to go fast but when maxed out it will need to lift 100-150 lbs.
If anyone could help me out I'd greatly appreciate it.

Thanks,
mreda

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 22:53.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.