Motor sizing - Chief Delphi

If all you are is a nail, every hammer looks like a problem. - Alan Anderson [more]

		Chief Delphi > Technical > Motors
Motor sizing

Thread Tools

Rate Thread

Display Modes

12-05-2016, 23:24

mreda

Registered User

no team

Join Date: May 2016

Location: NJ

Posts: 24

mreda is an unknown quantity at this point

Re: Motor sizing

what would you say would be the end goal for rpm. I was recommended previously to get a motor that would have cost me 150$ each and then I was going to have to get a motor driver as well which would have been another 100$ on top of that. This would definitely help the cost project if this ends up working out.

And I really appreciate your help with this. I know what I want to do, just not how to do it haha.

Last edited by mreda : 12-05-2016 at 23:30.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 22:54.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.