|
|
|
 That makes it a winning move to, well, win. - EricH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| That makes it a winning move to, well, win. - EricH [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
24-05-2016, 00:11
|
||||
|
||||
|
Re: Integrating Encoder Into Gearbox
We just ream a .25 hole and use some retaining compound to permanently attach our encoders to the hex shaft. The wires were then zip tied down without any slop preventing the encoder from rotating. I'm fairly sure 254 does the same thing. Never had any issues with structural integrity.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode