Team 254 Presents: Dropshot Technical Binder 2016

[lnex1357]

Originally Posted by Ashwin Adulla

.... the safety wire was wrapped once around the wheel, cut to its length, and then two ends were twisted together and then stuck inside the neoprene so as to prevent it from contacting the boulder. I have attached a picture of the flywheel below.

We are throwing some fairlane wheels on our shooter for an offseason event in place of our colsons. Did you guys use round or flat safety wire and what was the rough OD or width respectively, as I would prefer not to guess and check through a series of McM orders. Thanks so much!