|
|
|
 And then I learned how to use the lathe...long story short, I ditched my plans to become a music major and became an engineering student. - Karibou [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| And then I learned how to use the lathe...long story short, I ditched my plans to become a music major and became an engineering student. - Karibou [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#20
20-06-2016, 16:38
|
||||
|
||||
|
Re: Bearing Reamer?
I use a step bit most of the time. If the hole is a little big, I peen the edges. I use positive retention to locate the bearing so I am not depending on the press fit to do that. I had not thought about polishing the bit to make it a little smaller. Large dia twist drills tend to end poorly with sheet metal. When they grab, they will bend the sheet metal.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode