|
|
|
 Yeah, if we didn't have robots then we could concentrate on all that outreach stuff! - marshall [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Yeah, if we didn't have robots then we could concentrate on all that outreach stuff! - marshall [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: pic: 2x1 gearbox
So probably using 1/8" stock would be better. If the spacing inside is too little to fit anything in, then perhaps using 2x1.5 (I think this exists on McMaster) stock or something higher would be better. Unfortunately doing this would cause you to most likely lose the ability to integrate the gearbox into a drive rail
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
