Does anyone know how to ues gyro in Java

[cpapplefamily]

Originally Posted by SupremeSteak1

I know that it says this in the resources posted above, but I want to make sure to draw your attention to the fact that the gyro must be plugged into analog ports 0 or 1 or else it will not work. Our team failed to notice it at first and it caused us a lot of trouble.

Our team used the gyro this season and by chance it was plugged into port A0. Are you saying A0, and A1 are the only ports a Gyro will function on even if configured for the other analog port or just for these examples?

[Joe Ross]

Originally Posted by SupremeSteak1

I know that it says this in the resources posted above, but I want to make sure to draw your attention to the fact that the gyro must be plugged into analog ports 0 or 1 or else it will not work. Our team failed to notice it at first and it caused us a lot of trouble.

That applies to an analog gyro. However, the OP is using a digital gyro, the ADIS16448, so it doesn't apply.

Originally Posted by cpapplefamily

Our team used the gyro this season and by chance it was plugged into port A0. Are you saying A0, and A1 are the only ports a Gyro will function on even if configured for the other analog port or just for these examples?

It will only function on A0 and A1.

[cpapplefamily]

Originally Posted by Joe Ross

It will only function on A0 and A1.

We missed that in the documentation. We just luck out that we always used A0. Is this true for other devices? We have been trying without success to use a analog Ultrasonic on A5 in the MXP. Could explain a lot.