How to run GRIP in headless mode on the driver station?

Place a corner of it on the end of a table, clamp down the other side, and have a good whack at it with a hammer (hard). If it didn't break, it was polycarbonate. - vivek16 [more]

		Chief Delphi > Technical > Programming
How to run GRIP in headless mode on the driver station?

Thread Tools

Rate Thread

Display Modes

09-07-2016, 14:08

MaskedBandit1 MaskedBandit1 is offline

MaskedBandit1

AKA: Anurag

FRC #2383 (Ninjineers)

Team Role: Programmer

Join Date: Jan 2016

Rookie Year: 2015

Location: Florida

Posts: 4

MaskedBandit1 is an unknown quantity at this point

Re: How to run GRIP in headless mode on the driver station?

Hello, just wondering if there was ever any solution that was released allowing you to run grip in headless mode on driver station computer. Also, just to be clear, when you run GRIP on ds computer headless, you do not need a coprocessor on the robot such as a pi or jetson board correct? Thank you. I appreciate any forthcoming answers.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:31.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.