|
|
|
 Whatever the rule, MAKE IT CLEAR. - Bill Beatty [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Whatever the rule, MAKE IT CLEAR. - Bill Beatty [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
20-07-2016, 09:51
|
||||
|
||||
|
Re: pic: 25lb Drivetrain
I wouldn't even bother with holding the bearings in the tube. If you used screws and washers on the ends of the axles (or properly toleranced snap ring grooves) the bearings will have no where to go any way. 319 tapped the ends of our thunderhex shafts 1/4-20 and ran them all season without issues.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode