Bearing Reamer? - Chief Delphi

Well, air conditioners when pointed inside the house make it cooler. So I figure if EVERYONE turns their air conditioners on full blast and just point them out the window, we should more or less get rid of this "warming" nonsense. - Mike [more]

		Chief Delphi > FIRST > General Forum
Bearing Reamer?

Thread Tools

Rate Thread

Display Modes

#23

26-07-2016, 21:27

Fusion_Clint Fusion_Clint is offline

Registered User

AKA: Clint Brawley

FRC #0364 (Fusion)

Team Role: Mentor

Join Date: Apr 2014

Rookie Year: 2013

Location: Gulfport MS

Posts: 235

Fusion_Clint has a reputation beyond repute

Re: Bearing Reamer?

Quote:

Originally Posted by asid61

Good to know! Did you take any measurements of the final diameter? How tight was the press?

Did not measure the hole, I will on Thursday at our next meeting. However, I did measure the cutting blades and my Fowler Dial Caliper had them exactly 1.125" apart.

The fit was too tight to hand press the bearing in, but our little 1 ton arbor press put it easily and the bearing spun very nicely afterwards.

V/r

__________________
Clint Brawley
USAF 1992-2013
Fusion 364, 2014 Season to present

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:28.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.