Team 5254 HYPE 2016 CAD Release

[MaestroRoboto]

I can't seem to find the place where you mounted the BB sensor, could you point that out?

[AdamHeard]

Do you also happen to have w/e CAD you did for your Skystalker-er-er-er prototype?

[MaestroRoboto]

Originally Posted by AdamHeard

Do you also happen to have w/e CAD you did for your Skystalker-er-er-er prototype?

5kystalker-er-er-er prototype is almost the same as the CAD posted. The major differences are that their competition robot has a different collector, they switched to a mecanum wheeled intake, the two 'tomhawks' on the back with the omni wheels, different hard-stops for their shooter, and the climber.

[AdamHeard]

Originally Posted by MaestroRoboto

5kystalker-er-er-er prototype is almost the same as the CAD posted. The major differences are that their competition robot has a different collector, they switched to a mecanum wheeled intake, the two 'tomhawks' on the back with the omni wheels, different hard-stops for their shooter, and the climber.

Understood, it's just a great lesson in the prototyping and development process to be able to show the proto CAD, the proto video, the real CAD and then competition video.

[Maximillian]

Originally Posted by AdamHeard

Understood, it's just a great lesson in the prototyping and development process to be able to show the proto CAD, the proto video, the real CAD and then competition video.

I'll look and find the CAD for both our initial prototype robots. We built an initial robot that had a different arm and a 6-wheel drive and then switched to the final design. 5kystalker was the second prototype bot which then turned into our practice robot.

Here is a photo album of some photos throughout the process. You can also look at the technical binder on our website which shows some of our prototype progression.