|
|
|
 If you pay attention to every nut job on ChiefDelphi, you'll never reach a decision. - JesseK [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you pay attention to every nut job on ChiefDelphi, you'll never reach a decision. - JesseK [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
03-08-2016, 22:53
|
|||
|
|||
|
Re: Custom Gearboxes
Depending on your machining resources, don't forget about all the little stuff. The plates are the hard-to-machine part, but all the little bits (spacers, standoffs, shafts) can really add up time. With a bit of forethought, it's possible to do most of these COTS from AM/VEX/McM.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode