|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Using Talon Sr
So as an off-season project, I am wiring up a chassis for prototyping. We have a ton of Talon Srs (the older ones) to use instead of the Talon SRX. The plan is to put encoders on the drive train and have pneumatic shifting.
I am wondering how to wire up using the newer electronics system and CAN bus without motor controllers that run through CAN. How should I go about doing this and how can do I wire CAN? Any other advice would be helpful Thanks all! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|