|
|
|
 Polycord. It was used in all sorts of ball systems in 2009, and on some of the 2007 claws. It's not too hard to fuse together by hand with some heat and patience. - AustinSchuh [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#14
03-10-2016, 12:43
|
||||
|
||||
|
Re: Defeat STEAMPUNK WOODIE FLOWERS!
I cleverly swap out one of STEAMPUNK WOODIE FLOWERS's hip joint gear drives for an identical one, 3D printed with only 2 perimeters and 20% infill!
(This configuration should ensure that it will function identically to the original one for a short period of time, then fail catastrophically when STEAMPUNK WOODIE FLOWERS least expects it.) 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode