|
|
|
 I suspect the GDC is enjoying watching teams wrap their heads around this ranking algorithm.... and is probably a bit surprised that it has taken teams so long to clue in to the options this ranking system presents to them. - dtengineering [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: LabVIEW reentrant VIs
Thank you all very much for your replies. However, the issue turned out to be much more grave. The 5V analog in rail was only supplying a maximum of .3 volts
   ! We tried our hardest to clean out the RoboRIO but the problem still persisted. Sadly, the mentors are thinking that this is a bad RIO. It went through two rough seasons, so it had to go eventually. (But it just had to die 2 days before a competition ) We are borrowing a RIO from another team in the meantime. Again, thanks for all the help, and if you have any suggestions to bring a RoboRIO back from the dead, they'll be greatly appreciated. Jake 
|
|
#2
21-10-2016, 09:39
|
|||
|
|||
|
Re: LabVIEW reentrant VIs
The most reliable way is to contact NI for repair/replacement. AndyMark may also be a good place to start if it was purchased there.
Greg McKaskle
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Too much robots is still not enough. 
Hybrid Mode
