Quote:
Originally Posted by nuclearnerd
Our tubing and fittings are pretty much all the AndyMark stuff (not sure what brand). We have a few from McMaster Carr - I'll have to check which
I'm sure 1 through 3 were the causes of many failures, but I hadn't considered #4, thanks!
I was wondering if barbed fittings might be a more "fault tolerant" solution.
|
Barbed fittings are not the answer.
If really concerned about it you can go with a compression fitting but those have the draw back if not as easy to undo and service.
Where's the easy button on this thing... - Akash Rastogi [more] 
11-15-2016, 08:32 PM
Threaded Mode