|
|
|
 PS: Please use the default font for postings, it is so much easier to read. - DonRotolo [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| PS: Please use the default font for postings, it is so much easier to read. - DonRotolo [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#33
18-11-2016, 21:32
|
|||
|
|||
|
Re: 3D Printed Parts on an FRC Robot?
3D printed motor mounts on a horizontal flywheel shooter for stronghold held up fine. In my experience, problems with 3D printing models strength is usually a design flaw; though they are inherently weaker than non-3D printed parts, especially with ABS filament or stronger they are plenty strong, if well designed, for anything in FRC.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode