Custom Gearbox Without Automated Machining?

I don't thinks shorts should be allowed in the pits. Remember to insulate all of your wires! - Jalerre [more]

		Chief Delphi > Technical > Technical Discussion
Custom Gearbox Without Automated Machining?

Thread Tools

Rate Thread

Display Modes

19-11-2016, 14:30

swaxman12345 swaxman12345 is offline

Team Member

AKA: Sasha Waxman

FRC #2512 (Daredevils)

Team Role: CAD

Join Date: Oct 2015

Rookie Year: 2015

Location: Duluth

Posts: 48

swaxman12345 is an unknown quantity at this point

Re: Custom Gearbox Without Automated Machining?

Hi there,

Yes, last year my team manufactured custom gearbox plates on a traditional mill, even though we did CAD them first to make sure that they fit everything properly. It's a pain but if you have a capable machinist you should be fine.

__________________
Beware the Kraken, Jebediah. - Bill Kerman

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 21:58.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.