Rate my Talon SRX breakout (EagleCAD)

[Maxwell777]

Originally Posted by asid61

I have seen people use silicone glue like the kind found in waterproofing applications for insulation, but you might be better served with a simple printed case.

A case would probably be too bulky, the only things at risk of shorting are on the top side, so I figure It wouldn't be to hard to spread some over the top of each board. I was thinking of using some of this shoe-goo stuff we have, which is clear, stupidly strong, and fairly viscous and can be molded with soapy fingers so it's easy to apply, but I don't know of it's electrical properties. I think we may have some silicon glue laying around, so I may try both and see how I like them.