Rate my Talon SRX breakout (EagleCAD)

[Maxwell777]

Originally Posted by Daniel_LaFleur

I've used This before and it works well. I do HIGHLY recommend that you use it in a WELL ventilated area.
A low temp drying oven is the recommended way to cure this.

Now that you mention conformal coating it, I've also heard that it's possible to use nail polish as well. A spray-on like you suggested would probably work better though, speed up production of the 20-odd boards that I'm going to be making. I'll probably stick some tape over the solder pads to avoid coating those, as we need those for the board to work.