775pro .5" Hex Output Shaft

[Knufire]

Originally Posted by Sam Skoglund

Thanks for the input! It looks like I should either drill better holes in hex shaft, or use the 32DP gears. Does anyone know of a 5mm bore 5mm HTD pulley?

The reason I am doing this instead of a versaplanetary gearbox is because last year we had issues with shredding the weak little gears in the versaplanetary. Will the 12 tooth 32DP pinion gear from WCD hold up to high pressure is there are a few other stages after it in the gearbox? Or if it is a high stress mechanism, should I try to use the hex shaft adapter method instead?

SDP-SI has those pulleys.

A 6Z25M0xxDF0905 is the part number, where xx is the number of teeth (11-14)