Battery tab .stl file

[nick4130]

Hey y'all, on here before I saw that there was a battery tab holder that was able to be 3D printed, does anyone happen to have the .stl file for it? I cant seem to find it. Thank you!

[JR0405]

Here's a link to a blank one and one you can customize
http://www.thingiverse.com/search?q=...ttery+flag&sa=
Just printed a couple yesterday and they fit great

[mastachyra]

Is there a material that would be able to make that bridge where there is no material touching the base?

I usually try to avoid designing things like that, but I've only ever used the Cubify Ekocycle...

[ILAMtitan]

Originally Posted by mastachyra

Is there a material that would be able to make that bridge where there is no material touching the base?

I usually try to avoid designing things like that, but I've only ever used the Cubify Ekocycle...

Most modern filament should be able to bridge that gap just fine. Otherwise, support material can handle it.

[Lexeo]

Originally Posted by mastachyra

Is there a material that would be able to make that bridge where there is no material touching the base?

I usually try to avoid designing things like that, but I've only ever used the Cubify Ekocycle...

I've had some experience with the Cubify Ekocycle and if you install the latest firmware it tends to keep up with most printers okay. Worst case you will have to clean up the final part a little.

All of your standard filaments on most printers should be able to do a bridge like that (ABS,PLA,PET etc).

[jbotte]

Here is one you can you that just says "Charged"
http://www.team4909.org/charged-flag.html