Quote:
Originally Posted by PAR_WIG1350
It's an octagonal frame and belly pan, standing on its side. Given the lack of wheel cutouts along the edge closest to the table, and various holes placed elsewhere, it is uses four omni wheel, one at each corner short edge. The rivet mandrel stabbed into the table is just a distraction.
|
Swerve is also a possibility. The swerve modules might attach at the mounting holes in the bellypan. My question is, why does all your tubing and gussets look like it's been faced off on a mill or lathe?
That's a very pretty bellypan, by the way.
May your shirts be full of buttons, yours inspiration be plentiful, and your error messages be few. - Barry Bonzack [more] 
03-12-2016, 01:08
Threaded Mode