pic: ???

[SerpentEagle]

Originally Posted by PAR_WIG1350

It's an octagonal frame and belly pan, standing on its side. Given the lack of wheel cutouts along the edge closest to the table, and various holes placed elsewhere, it is uses four omni wheel, one at each corner short edge. The rivet mandrel stabbed into the table is just a distraction.

You have some very nice guessing skills

Originally Posted by Cothron Theiss

Swerve is also a possibility. The swerve modules might attach at the mounting holes in the bellypan. My question is, why does all your tubing and gussets look like it's been faced off on a mill or lathe?

That's a very pretty bellypan, by the way.

We use circular Scotch Brite pads with a drill press to polish our metal with swirls. It's fast, cheap, and looks amazing!

And thanks!

Originally Posted by RoboChair

Also, why the heck are you facing down your square parts on the lathe in a 4-jaw chuck? How bored are your students and who taught them that was a thing in the first place?

Originally Posted by RoboChair

They could have at least had the decency to properly center the parts in the jaws, but no we'll put it in offset and not worry about it.



Unless..... maybe they did it in the 3 jaw?

I have absolutely clue what your talking about lol