|
|
|
 Accidents happen, but they can be prevented with just a LITTLE bit of forethought. - AdamC [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Accidents happen, but they can be prevented with just a LITTLE bit of forethought. - AdamC [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
08-12-2016, 06:06
|
||||
|
||||
|
Re: New AM Shrink Tube Solder
We've used them for making PWM Y-cables many times and they have served us well. The finished splices are stronger than the wire at either end. We have never tried them on wire larger than 22 AWG.
They do require a lot of heat to melt the solder cylinder within, much more than most wire insulation can tolerate, so some care is needed to avoid damaging the wire insulation. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode