|
|
|
 FIRST will continue searching for rules and procedures to keep us from hurting ourselves. However, none of this will substitute for judicious application of common sense. - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
| View Poll Results: Did you like the new drill motors? | |||
| Yes |
  
|
48 | 68.57% |
| No |
  
|
22 | 31.43% |
| Voters: 70. You may not vote on this poll | |||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
17-04-2003, 21:16
|
|||||
|
|||||
|
The motors were just fine.
The motor mounts were crap...we had so much torque going through our drive that we would actually end up spinning the drill motors in their mounts until the brushes shattered and were spit out. Eventually we made an aluminum cross-support to hold the motor in place and we haven't had any problems since. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chiaphua Motors: Good or Bad to 2002 Kit Of Parts? | D.J. Fluck | Motors | 25 | 05-07-2002 16:40 |
| Complete Drill, Seat, and Window motors for trade | archiver | 2000 | 0 | 23-06-2002 22:16 |
| Complete Drill, Seat, and Window motors for trade | archiver | 2000 | 0 | 23-06-2002 22:16 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| what about the drill motors? | Ken Leung | Motors | 2 | 26-06-2001 02:11 |
Threaded Mode