Securing the Jetson TX1

[marshall]

Originally Posted by Type

By any chance do you have a picture of the final product? I believe I have only seen the render online, not the actual product.

Thingiverse has the old version. New version is going to have to wait.

Seriously, there are tons of options:

https://www.amazon.com/gp/product/B0...65ZTOPSIIDMP4V

https://www.amazon.com/Silverstone-A...+Computer+Case

Also, it comes mounted on a black plastic board thing as it is. You can pretty much run it on the robot without a case by velcro-ing that board down.

I suppose you'll want to know about powering it too. Buy one of these and save yourself a lot of headache:

http://a.co/csjNALF

Also of note, this system uses a 19V adapter out of the box but will run on 12V. IF YOU PLUG THAT 19V ADAPTER INTO YOUR OLDER TK1 (Notice I said TK1 and not TX1) THEN YOUR TK1 WILL GO BOOM.