|
Re: New AndyMark Product Game Hint???
Quote:
Originally Posted by Nick Lawrence
Emphasis mine.
We actually cut a bunch of samples over the summer in .025" increments to test this size, and found that .425" flat-to-flat is the right number for this specific profile and material combination. This number would change for a harder or thicker material, as well as a part with less holes in it.
-Nick
|
Ok, so should we see the hex shaft removing silicone from the inside of the hex when we press it in, or should the material stretch to fit around the hex shaft?
__________________
"It's taking longer than expected, which was to be expected."
|
Who needs daytime soaps when one can watch FRC matches? ;) - lkg9999 [more] 
Threaded Mode