NavX Micro Case

[cpapplefamily]

We found the case that is included to print did not work well. I sketched this up and it fit my board perfectly and with not broken tabs.

http://www.thingiverse.com/thing:1988260

[snoman]

Cool

[Poseidon5817]

Cool

[niklas674]

Cool?

[wsh32]

Cool!

[Bluman56]

~Cool~

[Harrison.Smith]

¡Cool!

[Poseidon5817]

Mission complete, good job men.



*Continue with serious discussion*

What exactly was wrong with the provided case that you needed to design a replacement? Would you say the issues were major, or minimal?

[Harrison.Smith]

In all seriousness, what prompted y'all to want a case for the NavX?

[cpapplefamily]

Originally Posted by Harrison.Smith

In all seriousness, what prompted y'all to want a case for the NavX?

Protection of the board and something to build a fastening system off of ie match holes in AM4U Chassis. The NavX (Micro) does not mount directly to the Roborio.

[asid61]

Very neat! I like your Kangaroo case too.

[Munchskull]

Could you post the CAD file too? That way I can use the model in my teams robot.

[rlance]

Originally Posted by cpapplefamily

We found the case that is included to print did not work well. I sketched this up and it fit my board perfectly and with not broken tabs.

http://www.thingiverse.com/thing:1988260

Thanks for posting this. I just ordered one from the web-site.

[cpapplefamily]

Originally Posted by Munchskull

Could you post the CAD file too? That way I can use the model in my teams robot.

I attached the .ipt part files and .step files to the thingiverse page. I know it can be at times difficult to take a thingiverse .stl thing and get it into Inventer but it can be done. I hope this part works well for all of you.

[cpapplefamily]

Originally Posted by asid61

Very neat! I like your Kangaroo case too.

Thank you. I didn't like how HOT it ran. Runs ice cold now.