|
|
|
 When's the last time you called up FIRST headquarters just to say thanks? Or saw a volunteer at a regional and said, 'Hey, you're doing a really great job here. Thank you for everything you're doing in your spare time.' - Amanda Morrison [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Encoder Mounting To Drive Train
So as the 2017 season slowly arrives, i've been trying to figure out how to mount a Greyhill 63R encoder to a WCP SS Gearbox. i understand that other teams are mounting it on the untapped hole at the end of the output shaft on the cim side. here is where i have a question
how do you properly secure the encoder to the Gearbox? does your team 3D print or make some kind of plate for it? then how did you stop it from rotating? Thank you for your time. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode