|
|
|
 Sometimes it's not what you know going into a battle, but who you know. - Elgin Clock [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Sometimes it's not what you know going into a battle, but who you know. - Elgin Clock [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Connector on Andymark Hall Effect Sensor
That's not what I want.
I want to not solder. I have breakout boards so I'd rather solder to that, but if I can find an IDC connector then I can just snap in a cable and be good 
|
|
#2
04-01-2017, 21:20
|
||||
|
||||
|
Re: Connector on Andymark Hall Effect Sensor
My team was in the progress of putting together a drivetrain using the Andymark swerve modules (am-3009) and were faced with the same problem, as the modules use hall effect sensors on the steering motors. We wanted to connect them directly to the TalonSRX's just as you do, and we ended up just using breakout boards; I'm guessing we could not find any of the cables you are looking for.
|
|
#3
04-01-2017, 22:36
|
||||
|
||||
|
Re: Connector on Andymark Hall Effect Sensor
if you get the above noted cable cut the power pole connectors off and solder to breakout board you would be done
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
