|
|
|
 Nobody has ever complained that someone was too willing to share their knowledge of building robots or their new ideas for anything. - Josh Hambright [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Nobody has ever complained that someone was too willing to share their knowledge of building robots or their new ideas for anything. - Josh Hambright [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
04-01-2017, 21:20
|
||||
|
||||
|
Re: Connector on Andymark Hall Effect Sensor
My team was in the progress of putting together a drivetrain using the Andymark swerve modules (am-3009) and were faced with the same problem, as the modules use hall effect sensors on the steering motors. We wanted to connect them directly to the TalonSRX's just as you do, and we ended up just using breakout boards; I'm guessing we could not find any of the cables you are looking for.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode