Our 2017 drive train

[Massako]

Originally Posted by mman1506

I'd suggest switching out those shaft clamps for 1/4-20 button heads with a washer in tapped holes on the ends of the hex shaft. Thunderhex stock comes pre drilled with the proper size hole for a 1/4-20 tap if you don't have a lathe. This will save some weight and cost. You could probably increase the distance between your wheels too which is always good thing.

Thanks yea. We already have over 50 of those hex shaft clamps and as well as the hex shaft but no lathe. I would like to do that but for simplicity sake its much easier since we don't have a lathe. I really appreciate your comment though.

Thanks