Wiring a router without a VRM

[Mark McLeod]

Originally Posted by Brutick

You can use 12V passive PoE to power the radio? The silk screening claims 18-24V PoE only. Unless you're using the 802.3af port which would violate R63?

We're looking into doing this, I ended up ordering some boost converters, but if I don't need them then I'm not going to use them.

Read the label on the back of the OM5P-AN radio.
Note: This is only for the older OM5P-AN radio. The New OM5P-AC is looking for 24v on the Passive POE port.

POE Input:12-24v in the port closest to the barrel input.
The 802 port wants 48v

[Brutick]

Originally Posted by Mark McLeod

Read the label on the back of the OM5P-AN radio.
Note: This is only for the older OM5P-AN radio. The New OM5P-AC is looking for 24v on the Passive POE port.

POE Input:12-24v in the port closest to the barrel input.
The 802 port wants 48v

Good to know. Thanks!

[frodobaggins05]

If you're just using it for testing I advise you just use an ethernet cable. It's much easier than all the work of setting up a bridge