|
|
|
 it doesn't matter so much why i joined [FIRST], but that i stayed :D - sure_smile [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| it doesn't matter so much why i joined [FIRST], but that i stayed :D - sure_smile [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Keying it Up
Hey,
Ok, so we ordered our steel shafts for the drive, and we have sprockets that have keyways as well as hubs that have keyways. We do not however have the ability to key our own stuff using a CNC or lathe, any other ways to key shatfs? I was thinking about putting a drill bit in a press, and moving the shaft by hand, but I'm almost sure the bit will just snap. Any ideas? Thanks. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode