|
|
|
 you should be putting forth you best effort every time you enter the field. - Protronie [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| you should be putting forth you best effort every time you enter the field. - Protronie [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
19-01-2017, 06:21
|
||||
|
||||
|
Re: Toughbox Hex Shaft With Magnet
Note that Andymark is now selling a short version of the shaft (probably a bit short, considering the long only sticks out 7mm). I'm not sure about the construction of the toughbox, but can't you just cut off a couple millimeters from the non-magnet side and push the shaft the outwards further?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode