|
|
|
 I check Chief Delphi more often than I check Facebook and Twitter combined. It's probably unhealthy actually... - Ginger Power [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I check Chief Delphi more often than I check Facebook and Twitter combined. It's probably unhealthy actually... - Ginger Power [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Problems with CAN and Roborio Web system configuration
We do not show a CAN interface on the web based system configuration for Roborio Any suggestions as to what may be causing this problem would be appreciated.
|
|
#2
19-01-2017, 10:01
|
||||
|
||||
|
Re: Problems with CAN and Roborio Web system configuration
We need a little bit more information. What do you have on your CAN network? Are these devices showing a CAN fault (see the documentation for each device to see what this looks like)? Is the CAN network properly terminated at the PDP or with a 20 Ohm resistor? Any other extraneous info might also be helpful in diagnosing your problem.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
