|
|
|
 We should all just be humble, courteous, and act like gentlemen (or ladies) on these forums, and not fill it with yakking about who's drive train is better. - Veselin Kolev [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Using encoder with Talon SRX
I have a problem with coding an Encoder that I'm using with Talon SRX. I want to get feedback from an Encoder and see if all motors are run at the same speed but I don't know how to write a code for it since I'm new at programming. Can I get an example code or more explanation about this information? Thank you!
|
|
#2
19-01-2017, 14:20
|
|||
|
|||
|
Re: Using encoder with Talon SRX
Read through the Talon SRX Software Reference Manual and take a look at the examples we have on GitHub.
If you have more questions after looking at these, feel free to e-mail support at ctr-electronics or post here and I'm sure folks will be able to help.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
