Mounting AMT10s to CIMs + gearboxes?

[trycatch]

Originally Posted by Munchskull

Try this.

Oooooh, that's *awesome*.

In response to the other questions, I was trying to figure out how you could mount the encoder to the CIM, and then the gearbox onto that, since the AMT10 just barely accepts the CIM output, and won't accept a 3/8" or 1/2" shaft, so putting the AMT10 onto the output of the gearbox wasn't an option.

This custom part here is a great solution!

[Munchskull]

Originally Posted by trycatch

Oooooh, that's *awesome*.

In response to the other questions, I was trying to figure out how you could mount the encoder to the CIM, and then the gearbox onto that, since the AMT10 just barely accepts the CIM output, and won't accept a 3/8" or 1/2" shaft, so putting the AMT10 onto the output of the gearbox wasn't an option.

This custom part here is a great solution!

PM me any question about how to implement this properly.