|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Motor Controllers Stop Working Below 50% Power in Labview
Rather than gear down our motors, we are trying to just drop the percentage of the power going through the motor controller in Labview. This works until we hit 50%(.5). Anything below 50.1% no longer works, as if no signal is going through to the motor controller. It is a spark motor controller if that helps.
![]() Last edited by RoboBucs : 26-01-2017 at 16:51. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|